Automotive Accessories

Tremec's Manual C8 Corvette Development Car Driven: Stock Tunnel Fits, Gearbox Costs $75,000

A track-prepared one-off shows the cable-shifted manual transaxle drops into the mid-engine Corvette's existing tunnel, with the gearbox alone priced at $75,000.

Rafael LindqvistNovember 17, 20265 min read2 views
A cutaway-style illustration of a mid-engine sports car cockpit with a gated manual shifter on the center tunnel and braided cables running rearward toward the transaxle.

Tremec has built a working manual-transmission version of the Chevrolet Corvette C8, and the company let a journalist sample the one-off development car on a private track outside Howell, Michigan. The vehicle, prepared by Peitz Performance as a race build, pairs Tremec's new manual transaxle with the mid-engine Corvette without relocating the gearbox.

The C8 was a turning point for Chevrolet. It was the first Corvette to put its engine behind the driver, and the first to be offered only with a dual-clutch automatic. According to the account, developing a pair of new transaxles — one manual, one automatic — was not in GM's budget, and executives are said to have chosen comparison-test competitiveness over pleasing a small group of manual enthusiasts. The piece frames that as an inference about internal deliberations rather than a stated company position.

Tremec is a plausible candidate to close the gap. It builds the TR-6060 six-speed used in GM performance models, including the Cadillac Blackwing line and the discontinued Camaro.

The test car is not a production prototype. Interior fit and finish is essentially absent: the shift lever protrudes from the space normally occupied by the storage cubby and automatic selector, the cabin is fully caged, and a full harness replaces the standard belts. Seat adjustment is minimal, which the reviewer — 5 feet 7 inches tall — said made heel-and-toe downshifts awkward, since he could not reach the floor to brace himself in corners.

Installation required less surgery than might be expected. The center tunnel had to be cut to accommodate the clutch pedal hardware, but the manual gearbox otherwise sits exactly where the stock dual-clutch unit would, with no special mating hardware required. The pedal box, according to the review, has ample room for a third pedal and feels roomier than the previous-generation Camaro's.

Shifter feel differs from a front-engine application. Because the transaxle sits behind the driver, the lever is remotely mounted and linked by cables running rearward. The result is less precise and less notchy than the direct mechanical linkage of a TR-6060 in a front-engine car, with a smoother action. The reviewer notes that some drivers will welcome the smoother feel while others will miss the mechanical character, and that the only fixes would be moving the engine forward or the shifter rearward.

Cost is the larger obstacle. The gearbox alone is quoted at $75,000, and combined with the price of the car, a completed manual C8 build lands near a showroom-spec Z06. Tremec says that figure will fall as volume rises, and that automakers beyond GM — none were named — have shown interest in a high-torque manual transaxle.

The drive itself took place on a green track on a November afternoon, conditions the reviewer acknowledged were far from ideal for a definitive verdict. Even so, the hardware worked: a manual C8 exists, it fits the standard tunnel, and the remaining barriers look commercial rather than technical.