Researchers in China have investigated how screen printing degrades copper-plated silicon heterojunction (HJT) solar cells and have proposed a modification to screen design intended to limit that damage during high-volume production.
Screen printing is widely used for metallization in solar cell manufacturing, but the mechanical pressure and thermal treatment involved can harm the sensitive passivating contact structures of HJT devices, raising recombination losses and lowering conversion efficiency. The issue is especially relevant for copper-plated HJT cells, which are seen as a route to cutting metallization costs and reducing reliance on silver.
Efficiency loss tracked across 15,000 cycles
Corresponding author Lang Zhou told pv magazine that photoresist printing for HJT cells differs fundamentally from conventional silver paste printing. In silver paste printing, screen openings account for only 2–5% of the total area, while the remaining surface is covered by an emulsion layer that keeps the mesh from touching the wafer. Full-area photoresist coating, by contrast, typically uses a screen without emulsion coverage so that resist is deposited uniformly across the wafer, meaning the mesh comes into direct and extensive contact with the wafer on every printing cycle.
Earlier work cited by the team showed conversion efficiency declining from 26.2% to 25.7% over 15,000 consecutive printing cycles in commercial production. The losses were attributed mainly to reductions in open-circuit voltage and fill factor, while short-circuit current density and electrical resistance remained largely unchanged. Minority carrier lifetime degradation rose from 0.61% with a new screen to 11.0% after 15,000 cycles.
Using three-dimensional confocal microscopy, the scientists identified progressive wear of the screen mesh knuckles as the main cause. As the knuckles wore down, their contact area with the wafer increased, placing greater mechanical stress on the passivation layers beneath. Scanning electron microscopy revealed no visible surface scratches, but photoluminescence measurements confirmed increased recombination losses, pointing to damage at the amorphous silicon/crystalline silicon interface.
Trade-off between protection and coating uniformity
To address the problem, the team developed an emulsion buffer layer that prevents direct contact between the mesh and the wafer surface. Six patterns were evaluated, with emulsion coverage ratios ranging from 2.9% to 16.6%.
The results showed a trade-off between mechanical protection and photoresist coating uniformity: higher emulsion coverage reduced damage but impaired ink distribution. A coverage ratio of 4.7% provided the best balance, limiting minority carrier lifetime degradation to 0.41% after 10,000 printing cycles while maintaining relatively good coating uniformity. The researchers attributed the improvement to the emulsion layer blocking direct mesh-to-wafer contact, thereby reducing cumulative mechanical damage to the sensitive passivation layers.
Zhou said the findings demonstrate that a relatively simple modification to screen design can substantially mitigate printing-induced degradation, offering a practical approach to improving the manufacturing reliability of copper-plated HJT solar cells.
The results were presented in the paper “Screen-printing photoresist induced efficiency degradation and mitigation in Cu-plated SHJ solar cells,” published in Solar Energy.
Copper metallization momentum
The development comes amid growing interest in copper as an alternative to silver-based contacts in HJT cells. In April 2026, researchers at China’s Nankai University reported a silver-free HJT solar cell with 25.2% efficiency using plasma-induced interface engineering and copper electroplating, an approach that addressed adhesion, contact resistance and stability challenges at the ITO interface.
Separately, scientists at Germany’s Forschungszentrum Jülich achieved 23.08% efficiency in a fully copper-metallized HJT cell, a relatively small penalty compared with its silver-metallized counterpart, while cells combining silver-copper paste on the front side with silver contacts on the rear reached 23.95% efficiency. Those findings underline copper’s potential to reduce silver consumption, although further improvements in processing and electrical performance remain necessary.
