Automotive Accessories

Builder Inverts Jeep Rear Differential for Budget Portal Axle

Zeph Gage pairs a Ford 9-inch housing with Humvee geared hubs and custom adapters in a rear-only conversion.

Astrid BerglundNovember 17, 20265 min read3 views
A workshop concept illustration shows a rear axle with an inverted differential, custom brackets and geared hubs beside an off-road tire.

Zeph Gage has built a rear portal axle for his Jeep using a Ford 9-inch housing, Humvee geared hubs and a set of HMMWV portal adapters from Jesse Haines Fabrication. The project is notable less for the parts list than for its layout: Gage inverted the rear differential so the driveline turns in the correct direction for the portal gears.

Portal axles are valued in hardcore off-roading because they place a gear stack at each driven wheel instead of relying on differentials and axle tubes that hang low. That raises the vehicle's ground clearance and lets tall tires fit without pushing every driveline component farther down. The trade-off is cost. A typical set from suppliers such as 74Weld costs about $20,000; Gage's rear-only arrangement costs about one-fifth as much.

Two-gear portals, including the Humvee units used here, reverse the rotation of the input shaft. To make that work with the Ford 9-inch, Gage turned the differential upside down. A Yukon Gear and Axle third member was then bolted to the inverted housing. The result is a budget high-pinion setup built from low-pinion parts turned upside down, avoiding the need for a dedicated high-pinion housing.

Rear-only compromise with practical benefits

Gage did not add a matching portal axle to the front. Keeping the front solid axle avoids the packaging problems that can arise when portal hardware is fitted to a vehicle that never had it from the factory. It also leaves room for full shock travel and keeps the ride height from becoming excessively tall. The same rear-only approach is common in remote-control rock crawling.

The design is intended to add about six inches of clearance while retaining full suspension travel and reducing stress on the differential. That combination is meant to make the rear end highly durable, though the claim is a design assessment rather than a tested guarantee.

This is not a bolt-on kit. Gage carried out custom fabrication, including homemade brackets, custom-tapped plates and a two-piece brake rotor matched to a Ford Fusion caliper. The Fusion caliper was chosen partly because it has an integrated electric parking-brake solenoid and also helps with clearance.

The finished XJ Jeep is said to clear a five-gallon bucket with several inches to spare. That matters off-road because the rear end is less likely to hang up on obstacles that the front axle can steer around. More detail on the build, including how Gage matched front and rear gearing, is available in an Outdoor Auto video.